Home » Flow Meter » Electromagnetic Flow Meter » Mass method calibration with 5 points according to ISO 17025 liquid flow meter

Mass method calibration with 5 points according to ISO 17025 liquid flow meter

Q&T calibration equipment for liquid flow meter is DN3-DN3000, standard accuracy is 0.5%, 0.2% is optional. Calibration method of electromagnetic flow meter: non-contact measurement method. That is, the external ultrasonic flowmeter is clamped on the pipe of the measured flowmeter. By comparing the cumulative flow error of the two flowmeters.
Structure: compact, remote
Liner: PTFE, PFA, Polyurethane, Neoprene, Hard Rubber, Ceramic
Protection Grade: IP65 std, IP68 optional for remote
Size: DN3-DN3000
Sensor material: carbon steel (std), SS304 / SS316 (optional)
Measuring tube: SS304

Rated 4.7/5 based on 270 customer reviews
Share:
Content
Inquiry


    More Electromagnetic Flow Meter

    magnetic flow meter (mag meter, electromagnetic flow meter) is a transducer that measures fluid flow by the voltage induced across the liquid by its flow through a magnetic field. A magnetic field is applied to the metering tube, which results in a potential difference proportional to the flow velocity perpendicular to the flux lines. The physical principle at work is electromagnetic induction. The magnetic flow meter requires a conducting fluid, for example, water that contains ions, and an electrical insulating pipe surface, for example, a rubber-lined steel tube.
    If the magnetic field direction were constant, electrochemical and other effects at the electrodes would make the potential difference difficult to distinguish from the fluid flow induced potential difference. To show this in modern magnetic flowmeters, the magnetic field is constantly reversed, cancelling out the electrochemical potential difference, which does not change direction with the magnetic field. This however prevents the use of permanent magnets for magnetic flowmeters.
    Size: 1/8″-120″
    Accuracy: ±0.5%
    Electrode: SUS316L, Hastelloy B, Hastelloy C
    Structure: compact, remote
    Liner: PTFE, PFA, Polyurethane, Neoprene, Hard Rubber, Ceramic
    Output Signal: 4~20 mA, Pulse
    Communication: RS485, HART, PROFIBUS
    Protection Grade: IP65 std, IP68 optional for remote
    Power supply: 85~250 VAC, 20V~36VDC, 3.6V lithium battery
    Sensor material: carbon steel (std), SS304 / SS316 (optional)
    Flange: ANSI, DIN, JIS, etc.