A thermal mass flow meter can fail and still look fine. Display’s on, output still reads 4 mA, the number is off. The element has drifted or taken damage, and you can’t see it from outside.
So you measure resistance: cover off, display board out, meter on ohms, probes on the element leads. The reading jumps, then settles after a second or two. If it matches the nameplate or the manual, the element is fine. If you see OL, or something well off that figure, it’s done. Recalibrating won’t bring it back, so replace it.
Red and black either way round reads the same, so polarity doesn’t matter. Take it at room temperature, the element reacts to heat and your hand shifts the number.
You need a screwdriver and a meter that reads ohms.