Home » Video » operation video » How to check Resistance value of thermal mass flow meter
How to check Resistance value of thermal mass flow meter

How to check Resistance value of thermal mass flow meter

A thermal mass flow meter can fail and still look fine. Display’s on, output still reads 4 mA, the number is off. The element has drifted or taken damage, and you can’t see it from outside.

So you measure resistance: cover off, display board out, meter on ohms, probes on the element leads. The reading jumps, then settles after a second or two. If it matches the nameplate or the manual, the element is fine. If you see OL, or something well off that figure, it’s done. Recalibrating won’t bring it back, so replace it.

Red and black either way round reads the same, so polarity doesn’t matter. Take it at room temperature, the element reacts to heat and your hand shifts the number.

You need a screwdriver and a meter that reads ohms.

Rated 4.7/5 based on 418 customer reviews
Share:
Content

Introduction

Flange thermal gas mass flow meter is one of kind mass flow meter which
Is popular in industrial applications is the way they are designed and built. The feature is no moving parts, nearly unobstructed straight through flow path, require no temperature or pressure corrections and retain accuracy over a wide range of flow rates. Straight pipe runs can be reduced by using dual-plate flow conditioning elements and installation is very simple with minimal pipe intrusions.
Flange thermal gas mass flow meter size from DN10~DN2000mm

Advantages

 

Flange thermal gas mass flow meter advantanges :

 

(1)Wide range ratio 1000:1;
(2)Large diameter, low flow rate, negligible pressure loss;
(3)Direct mass flow measurement without temperature and pressure compensation;
(4)Very sensitive for low flow rate measurement;
(5)Easy to design and select, easy to install and use;
(6)Suitable for all kinds of single or mixed gas flow measurement Could measure gas with flow velocity from 100Nm/s to 0.1Nm/s, which can be used for gas leak detection;

(7) The sensor has no moving parts and pressure sensing parts, and is not affected by vibration on the measurement accuracy. It has good seismic performance and high measurement reliability;

(8) No pressure loss or very small pressure loss.
(9) When measuring the gas flow, it is often expressed in the volume flow unit under the standard state, and the medium temperature/pressure change hardly affects the measured value. If the density is constant in the standard state (that is, the composition is unchanged), it is similar to a mass flow meter;

(10) Support multiple communication methods, such as RS485 communication, MODBUS protocol, etc., which can realize factory automation and integration

Application

Flange thermal gas mass flow meter application:

Thermal gas air flow meter widely use for Electric power, Petrochemical industry, Glass, Ceramics and Building materials industry, and mainly be used to meausre Dry gas, such as Air, Natural gas, LPG gas, Biogas, ect. But thermal gas mass flow couldn’d be used to measure Vapour, Humidity gas and Ethyne.

Inquiry


    More operation video